Soldering iron with ceramic heater Tip - cone with an end face of 0.4 mm, durable, chrome-plated.
5-pin connector, i.e. soldering iron without motion sensor.
It is also possible to use it with soldering stations of other manufacturers, designed to work with a soldering iron with a HAKKO 1321 heater.
Soldering iron with ceramic HAKKO1321, built-in resistive-type temperature sensor, supply voltage 24V, power 60-75 W.
Sting - cone with an end face of 0.4 mm, durable, chrome-plated.
Heater made of conductive ceramic with built-in resistance-type temperature sensor. Such a heater, in comparison with nichrome, with an equal rated power, has better heating dynamics, the temperature is measured more accurately and is more durable.
Heater parameters: in a working element, the resistance between the heater terminals is about 3-4 Ohms, the resistance between the terminals of the temperature sensor is about 50-60 Ohms.
It is also possible to use with similar soldering stations from other manufacturers, designed to work with a soldering iron equipped with a HAKKO1321 heater, i.e. with a thermistor as a temperature sensor. You only need to replace the connector.
For example, this soldering iron is suitable for Lukey-868 and Lukey-852D+stations, if you changeconnector or connect viaadapter.
To connect the soldering iron to non-original control units (homemade or from other manufacturers), you can use the following mating connector parts:
for installation on the device body
All soldering irons are 100% pre-tested. The tip and heating element of the soldering iron are consumable items and are not covered by the warranty.
The data presented in the product description are for reference only and may differ from those indicated by the manufacturer.
